A USB-C to USB-A cable is required to connect your Nintendo Switch to your PC.They are relatively cheap and easy to acquire online.A RCM Jig is required to enter your Switch into RCM mode (Recovery Mode).The serial number can also be found from the Nintendo Switch Home menu in -> ->.Visit and enter your Switch’s serial number (found on the white strip next to the USB port) to check if your Switch is hackable.Not all Nintendo Switch consoles can be hacked your Switch must be an earlier model (determined by the serial number) that is vulnerable to the fusee-gelee exploit.If you wish to remove custom firmware and start ‘fresh’, follow this guide on using Haku33 to ‘clean’ your Switch NAND. This is only recommended if you have NEVER used custom firmware on the console before. This will allow you to boot into both custom firmware and the stock firmware on the same Switch, without ‘contaminating’ the console’s internal storage. This means a copy of your Switch internal storage containing custom firmware can be run directly from the SD card without leaving any files on your actual console.įollow this guide on setting up EmuNAND on your fresh Nintendo Switch. If you wish to play online AND have access to homebrew features, you can setup an emulated Switch storage (EmuMMC / EmuNAND) partition on your SD card. You should never attempt to play online once you have installed a custom firmware on your Nintendo Switch due to the high likelihood of a ban. This is to prevent your Switch sending information that could lead to a ban as an Internet connection is required to use Tinfoil / HBG Shop. Before you begin, it is strongly advised to Block Nintendo Servers via DNS.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |